Yeah, that's the confusion. Hygros read 65-66 the whole time, but wineador reading started at 69 and is now steady at 57. So far I'm trusting the hygros.Quote:
Originally Posted by projectsunfire
Printable View
Yeah, that's the confusion. Hygros read 65-66 the whole time, but wineador reading started at 69 and is now steady at 57. So far I'm trusting the hygros.Quote:
Originally Posted by projectsunfire
Yep. HF. I think the RH issue is related to the cooling cycle. And they are trying to rebound now. The fan on the TEC is still running but not cooling. I think that is normal for this model, but might be affecting the RH a little as well.Quote:
Originally Posted by HabanoMan
That's what I think too. Wouldn't worry much about the Rh then. They will recover and return it to normal. I just hope that the temp. reading on the hygros are accurate and not the on on the unit. :thumb:
It's possible that the air flow inside the unit just needed to equalize. It's also possible that your hygrometers need new batteries?
I would think the hygros would be the accurate ones, because the unit is set to 66, and the ambient is about 72. I doubt the unit would get to 57 and stay there with these factors. But I'm still hoping a wineador owner has seen this before and it's just the display being off. If things are still wonky tomorrow, I'll calibrate the hygros again (just did it a month ago) and check their temp readings. The batteries are only a year old, but they may need replacing as well.
I have found that the temp on the unit its self it off by a few degrees. I bet with the fans kicking on, its moving the air around and causing problems for you.. I would wait 24 hours as well.. It will settle down..
Layne, mine does exact same thing. I also have a temp controller wired into mine. My hygro's and temp controller right now are reading 65.2f and my wineador door is showing 57. I've found to never pay attention to door display. The program temp keeps it where it should but door display will be off for hours. Them out of blue it will be accurate for hours, and so on.
No actual fluctuation in temp, just door display is wacky.
If the thermal readouts of the hygrometers have previously been accurate, I would trust them over the wineador's built-in gauge. That's because the works of the wineador are having to work harder than usual during start-up and the wineador's built-in temperature sensor may be located near the cooler itself, while the rest of the interior hasn't cooled down yet; the hygros are (I'd presume) on shelves along with the cigars, which should provide them with a little insulation against conductive cooling.
As for the drop in humidity, I'm going to make two assumptions. One, the HF beads are in the bottom of the wineador, which is probably the coldest part of the unit. Two, the hygrometers are higher in the wineador, probably on Spanish cedar shelves along with cigars. If these assumptions are valid, here's what's happening:
As the wineador cools, the interior walls (at least near the bottom) cool first and then take heat from the warmer air. Cooler air is denser than warm air, so it tends to stay near the bottom; but cool air doesn't hold as much absolute humidity as warmer air, which helps explain why really hot-and-humid summer days are so oppressive while cool-and-humid days in early spring and late fall are much more comfortable. (The only times when absolute humidity and relative humidity are the same are at zero percent and 100 percent. Between those two extremes, meteorologists and cigar lovers need only pay attention only to the RH.) The important thing is, when the moisture in the colder air condenses and/or returns to the beads, the drier air is then lighter and can rise. (Rainclouds do the same thing to get over mountains.) This dry air is what the hygrometers are measuring; yes, the air around the hygrometers -- and cigars -- really is too dry.
If the RH stayed that low very long your cigars might dry out enough to suffer damage; more likely, an RH in the mid-50s to mid-60s would only slow the aging process, and make them too dry for proper smoking. The good news is that HF beads regulate relative humidity rather than absolute humidity. When the temperature equalizes throughout the wineador, the beads will be able to respond to the lower RH by releasing moisture.
You might be able to speed the process slightly by misting the beads with distilled water, if they are not already close to being fully hydrated. But odds are, you don't need to do that; the RH should return to where you want it to be before the cigars' fillers know anything has happened, and the binders and wrappers will return to your desired RH quickly, none the worse for their brief experience.
If you have any doubts, or if the RH hasn't begun rising by morning, transfer the cigars to ziplock baggies or tupperdors with Boveda packs until the temperature and RH within the wineador return to where they should be.
Thanks. I almost tagged you knowing you'd have an answer. What I'm seeing is exactly what you're seeing, so now I'll sleep well. :)Quote:
Originally Posted by Trackmyer